2004 Subaru Baja Owner's Manual - Page 105
2004 Subaru Baja Manual
Page 105 highlights
Keys and doors 2. The alarm will sound. 3. Insert the key into the ignition switch and cycle it from "LOCK" to "ON" three (3) times within 5 seconds. the "UNLOCK/DISARM" button pressed for more than two seconds. The indicator will stop flashing. ! Passive arming When passive arming mode has been programmed by the dealer, arming of the system is automatically accomplished without using the remote transmitter. Note that in this mode, DOORS MUST BE MANUALLY LOCKED. ! To enter the passive mode ! Sounding a panic alarm To activate the alarm, keep the "LOCK/ARM" button pressed for more than two seconds. The horn will sound and the turn signal lights will flash. To deactivate it, press the "LOCK/ARM" button or "UNLOCK/DISARM" button. Unless a button on the remote is pressed, the alarm will be deactivated after approximately 30 seconds. ! Valet mode When you choose the valet mode, the security system does not operate. In valet mode, the remote transmitter is used only for locking and unlocking the doors and panic activation. To enter the valet mode, open the driver's door and keep the "UNLOCK/DISARM" button depressed for more than two seconds. The security system indicator light will continue to flash 2 times per second indicating that the system is in the valet mode. To exit valet mode, open the driver's door and keep 2-18 Do not disconnect or tamper with any yellow connector and/or any harness covered with yellow insulation and/or tape. Doing so could result in accidental inflation of the SRS airbag or could make the SRS airbag system inoperative, which may result in serious injury.