2004 Subaru Outback Owner's Manual - Page 156

Instruments and controls ABS warning light (U.S.) (Canada) NOTE The ABS warning light comes on when the ignition switch is turned to the "ON" position and goes out after about two seconds. This is an indication that the ABS system is working properly. If the warning light behaves as follows, the ABS system may not work properly. When the warning light is on, the ABS function shuts down; however, the conventional brake system continues to operate normally. The warning light does not come on when the ignition switch is turned to the "ON" position. The warning light comes on when the ignition switch is turned to the "ON" position, but it does not go out even when the vehicle speed exceeds approximately 8 mph (12 km/h). The warning light comes on during driving. If these occur, have the ABS system repaired at the first available opportunity by your SUBARU dealer. If the warning light behavior is as described below, the ABS system may be considered normal. The warning light comes on right after the engine is started but goes out immediately, remaining off. The warning light remains on after the engine has been started, but it goes out when the vehicle speed reaches about 8 mph (12 km/h). The warning light comes on during driving, but it goes out immediately and remains off. When driving with an insufficient battery voltage such as when the engine is jump started, the ABS warning light may come on. This is due to the low battery voltage and does not indicate a malfunction. When the battery becomes fully charged, the light will go out. VDC (Vehicle Dynamics Control) warning light (if equipped) This warning light comes on when the ignition switch is turned to the "ON" position and goes out after the engine has started. It indicates that the VDC system is operational. The VDC system is probably inoperative under any of the following conditions. Immediately have your vehicle checked at a SUBARU dealer. - CONTINUED - 3-13