2004 Subaru Outback Owner's Manual - Page 124

Keys and doors To arm the system using power door locking switches 1. Close all windows and moonroofs (if so equipped). 2. Remove the key from the ignition switch. 3. Open the doors and get out of the vehicle. 4. Make sure that the engine hood (and the trunk lid) is locked. 5. Close the doors (and the rear gate on the station wagon) but leave only the driver's door or the front passenger's door open. indicator light will start flashing slowly (approximately once every two seconds) to inform you that the system has armed. NOTE The system can be armed even if the engine hood, the windows and/or moonroofs are opened. Always make sure that they are fully closed before arming the system. Disarming the system Briefly press the "UNLOCK/DISARM" button (for less than two seconds) on the remote transmitter. The driver's door will unlock, an electronic chirp will sound two times, the turn signal lights will flash two times and the indicator light will go off. To unlock all other doors (and the rear gate on the station wagon), briefly press the "UNLOCK/DISARM" button a second time. 6 7 UB2024CC 6. Push the power door locking switch forward ("LOCK" side) to set the door locks. 7. Close the door. An electronic chirp will sound one time, the turn signal lights will flash one time and the Emergency disarming If you cannot disarm the system using the transmitter (i.e. the transmitter is lost, broken or the transmitter battery is too weak), you can disarm the system without using the transmitter. To disarm the system: - CONTINUED - 2-17