2004 Subaru Outback Owner's Manual - Page 128

Keys and doors DISARM" button on the transmitter. Tripped sensor identification If an electronic chirp sounds four times and the turn signal lights flash four times when you disarm the system, this indicates that the alarm was triggered. The number of times the indicator light flashes indicates what sensor caused the alarm condition. To enter identification mode: 1. Open the driver's door and leave it open. 2. Turn the ignition switch to the "ON" position two times. ("LOCK" → "ON" → "LOCK" → "ON" → "LOCK") 3. The indicator light will start flashing. The indicator light provides the following indications. Flashing one time: Any door, the rear gate or the trunk lid has been opened. Flashing three times: The impact sensor in the system's unit has been activated. This may indicate that your vehicle has been shocked or tampered with by some outside force and/or unauthorized person. Flashing four times: The ignition switch has been turned on or the battery has been disconnected. 4 3 5 UB2024DB 3. Open the doors and get out of the vehicle. 4. Before closing the doors, lock all doors with the inside door lock levers. 5. Close the doors. The system will automatically arm after one minute. In the passive mode, the system can also be armed with the remote transmitter or with the power door locking switches. If the remote transmitter or power door lock switch is used to lock the vehicle, arming will take place immediately regardless of whether or not the passive mode has been selected. Disarming the system To disarm the system, briefly press the "UNLOCK/ NOTE The battery must be reconnected before the indicator light will flash. - CONTINUED - 2-21