2007 Subaru B9 Tribeca Owner's Manual - Page 142
2007 Subaru B9 Tribeca Manual
Page 142 highlights
Instruments and controls 3-19 ingly, if the ABS is inoperative, the Vehicle Dynamics Control system becomes unable to provide ABS control. As a result, the Vehicle Dynamics Control system also becomes inoperative, causing the warning light to come on. Though both the Vehicle Dynamics Control and ABS systems are inoperative in this case, the ordinary functions of the brake system are still available. You will be safe while driving with this condition, but have your vehicle checked at a SUBARU dealer as soon as possible. It also comes on when the Traction Control system is deactivated. Security indicator light NOTE NOTE The light may stay on for a while after the engine has been started, especially in cold weather. This does not indicate the existence of a problem. The light should go out as soon as the engine has warmed up. The indicator light comes on when the engine has developed a problem and the CHECK ENGINE warning light/ Malfunction indicator lamp is on. The Vehicle Dynamics Control system is probably faulty under the following condition. Have your vehicle checked at a SUBARU dealer as soon as possible. The light does not go out even after the lapse of several minutes (the engine has warmed up) after the engine has started. 200702 If the warning light behavior is as shown in the following, the Vehicle Dynamics Control system may be considered normal. The warning light comes on right after the engine is started but goes out immediately, remaining off. The warning light comes on after engine startup and goes off while the vehicle is subsequently being driven. The warning light comes on during driving, but it goes out immediately and remains off. Traction Control system OFF indicator light It comes on when the Traction Control system OFF switch is pressed. The indicators are located in the center portion of the dashboard. This indicator light shows the status of the alarm system. It also indicates operation of the immobilizer system. Alarm system It blinks to show the driver the operational status of the alarm system. For detailed information, refer to the "Alarm system" section in chapter 2. Immobilizer system This light blinks approximately 60 seconds after the ignition switch is turned from "ON" position to the "ACC" or "LOCK" position or immediately after the key is pulled out. (Refer to the "Door locks" section in - CONTINUED -