2007 Subaru B9 Tribeca Owner's Manual - Page 224

Interior equipment 6-21 NOTE If your vehicle is washed with a high-pressure washer, do not allow water to contact the camera directly. Entry of water in the camera lens may result in condensation, malfunction, fire or electric shock. Since the camera is a precision device, do not subject it to strong impacts. Otherwise, malfunction, fire or electric shock may occur. If mud or snow sticks to or is frozen on the camera, you must be very careful removing it. Otherwise, damage done to the camera may cause a fire or electric shock. Pour lukewarm water over the camera to remove mud or ice. Do not put a flame close to the camera or wiring. Otherwise, damage or fire may occur. When replacing the fuse, be sure to use a fuse with the specified rating. Use of a fuse with a different rating may result in a malfunction. If the rear view camera is used for a long time while the engine is not operated, the battery may become completely discharged. Position of rear view camera Do not wipe the camera with alcohol, benzine or paint thinner. Otherwise, discoloration may occur. To remove contamination, wipe the camera with a cloth moistened with a diluted neutral detergent and then wipe it with a dry cloth. When waxing the vehicle, be careful not to apply the wax to the camera. If it comes in contact with the camera, moisten a clean cloth with a diluted neutral detergent to remove the wax. The camera lens has hard coating to help prevent scratches. However, when washing the vehicle or cleaning the camera lens, be careful not to scratch the camera lens. Do not use a washing brush directly on the camera lens. The monitor screen may be adversely affected. Strong light shined on the camera lens may develop white light stripes around the light source. This is not a malfunction. 600563 It is attached to the rear gate. How to use the rear view camera To display the rear view camera image When the selector lever is set to "R", the rear view camera automatically displays the rear view image from the vehicle. When the lever is set to other positions, the image before setting to "R" is displayed. 1. Set the ignition switch to "ON". 2. Set the selector lever to "R". - CONTINUED -