2008 Subaru Impreza Owner's Manual - Page 122

3-6 Instruments and controls & Canceling the function for meter/gauge needle movement upon turning on the ignition switch when the ignition switch is in the "LOCK" or "Acc" position. & Speedometer The speedometer shows the vehicle speed. & Odometer/Trip meter *1: WRX STI only " cannot be displayed *2: " " or " when the ignition switch is in the "ON" position. It is possible to activate or deactivate the movement of the meter needles and gauge needles that takes place when the ignition switch is turned to the "ON" position. Turn the ignition switch to the "LOCK" or "Acc" position. " Press the trip knob to show " " or " on the odometer and trip meter display. The display can be switched as shown in the following illustration by pressing the trip knob. To change the current setting, press the trip knob for at least 2 seconds. : Activated : Deactivated NOTE . Your vehicle's initial movement setting of the meter/gauge needles has been set for activation " " at the time of shipment from the factory. . It is not possible to cancel the initial movement setting of the meter/gauge needles when the ignition switch is in the "ON" position. Cancel the setting 1) Trip knob This meter displays the odometer and two trip meters when the ignition switch is in the "LOCK", "Acc" or "ON" position. If you press the trip knob when the ignition switch is in the "LOCK" position, the odometer/trip meter will light up. It is possible to switch the indications while the odometer/trip meter is lit up. If you do