2008 Subaru Legacy Owner's Manual - Page 239
2008 Subaru Legacy Manual
Page 239 highlights
Interior equipment 6-19 your garage door opener may be protected by a rolling code feature. In this case you need to perform the additional steps for "Programming rolling-code-protected garage door openers in the U.S.A." described in the following. may make the programming quicker and easier. NOTE Rolling-code-protected garage door openers are manufactured after 1996. See the instruction manual of your garage opener for confirmation. 4. Using both hands, simultaneously push the hand-held transmitter button and the desired HomeLink® button. DO NOT release the buttons until step 5 has been completed. 5. Hold down both buttons until the HomeLink® indicator light flashes, first slowly then rapidly. When the indicator light flashes rapidly, both buttons may be released. (The rapidly flashing light indicates successful programming of the new frequency signal.) 6. Press and hold the programmed button and check the HomeLink® indicator light. If the indicator light stays on continuously, your garage door should activate and the programming is completed. If the indicator light flashes rapidly for 2 seconds and then stays on continuously, 7. Reconnect the motor of your garage door opener to the outlet. 8. Test your garage door opener by pressing the programmed HomeLink® button. & Programming rolling-codeprotected garage door openers in the U.S.A. If your garage door opener has a rolling code feature, program the HomeLink® Wireless Control System for it by following steps 1 through 5 in the "Programming garage door openers in the U.S.A." section above and then continuing with the following steps. 1. Locate the training button on the garage door opener motor head unit. The exact location and color of the button may vary by brand of garage door opener. If it is difficult to locate the training button, refer to your garage door opener's instruction manual. NOTE The assistance of a second person - CONTINUED -