2009 Subaru Forester Owner's Manual - Page 134

Instruments and controls 3-23 "ON" position, the indication does not flash. NOTE The outside temperature indication may differ from the actual outside temperature. The road surface freeze warning indication should be treated only as a guide. Be sure to check the condition of the road surface before driving. Pressing the trip knob toggles the indication between the average fuel consumption corresponding to the A trip meter indication and the average fuel consumption corresponding to the B trip meter indication. When either of the trip meter indications is reset, the corresponding average fuel consumption value is also reset. ! Turn off display of average fuel consumption indicator The display of the average fuel consumption indicator can be turned off. To turn off the display of the indicator, turn the ignition switch to the "LOCK" position and press the "+" button adjacent to the information display for approximately 5 seconds. Then, the information display and the clock display will blink for 3 seconds to notify that the display of the average fuel consumption has been turned off. To restore the indicator, once again press the "+" button for approximately 5 seconds. treated only as a guide. . When either trip meter indication is reset, the average fuel consumption corresponding to that trip meter indication is not shown until the vehicle has subsequently covered a distance of 1 mile (or 1 km). & Average fuel consumption 1) 2) U.S.-spec. models Canada-spec. models NOTE . The indicated values vary in accordance with changes in the vehicle's running conditions. Also, the indicated values may differ slightly from the actual values and should thus be This indication shows the average rate of fuel consumption since the trip meter was last reset.