2009 Subaru Legacy Owner's Manual - Page 403

Maintenance and service 11-53 ! High beam light bulbs 2. Use a screwdriver to remove the secured clip of the washer tank. To make it easy to access the bulb, move the washer tank to the horizontal direction. (left-hand side) place and secure it by clip. (left-hand side) & Front turn signal/Parking and front side marker light It may be difficult to replace the bulbs. Have the bulbs replaced by your SUBARU dealer if necessary. & Front fog light (if equipped) It may be difficult to replace the bulbs. Have the bulbs replaced by your SUBARU dealer if necessary. Right-hand side & Rear combination lights ! Sedan 3. Disconnect the electrical connector from the bulb. 4. Remove the bulb from the headlight assembly by turning it counterclockwise. 5. Replace the bulb with new one. At this time, use care not to touch the bulb surface. 6. Reconnect the electrical connector. 7. To install the bulb to the headlight assembly, turn it clockwise until it clicks. 8. Install the air intake duct with clips. (right-hand side) 9. Set the washer tank to the original 1. Use a screwdriver to undo the clips on the air intake duct, then remove the air intake duct. (right-hand side) Left-hand side 1. Push the knobs of the cover to open the cover. - CONTINUED -