2007 Volvo S60 Owner's Manual - Page 95

Refueling CAUTION! - Do not refuel with the engine running1 . Turn the ignition off or to position I. If the ignition is on, an incorrect reading could occur in the fuel gauge. - After refueling, close the fuel filler cap by turning it clockwise until it clicks into place.1 - Avoid overfilling the fuel tank. Do not press the handle on the filler nozzle more than one extra time. Too much fuel in the tank in hot weather conditions can cause the fuel to overflow. Overfilling could also cause damage to the emission control systems. - Avoid spilling gasoline during refueling. In addition to causing damage to the environment, gasolines containing alcohol can cause damage to painted surfaces, which may not be covered under the New Vehicle Limited Warranty. - Do not use gasolines containing methanol (methyl alcohol, wood alcohol). This practice can result in vehicle performance deterioration and can damage critical parts in the fuel system. Such damage may not be covered under the New Vehicle Limited Warranty. 1. If the fuel filler cap is not closed tightly or if the engine is running when the vehicle is refueled, the Check Engine Light (malfunction indicator lamp) may indicate a fault. However, your vehicle's performance will not be affected. Use only Volvo original or approved fuel filler caps. pg. 111 Starting and driving Starting the vehicle Starting the engine - Fasten the seat belt. WARNING! Before starting, check that the seat, steering wheel and mirrors are adjusted properly. Make sure the brake pedal can be depressed completely. Adjust the seat if necessary. See pages 80 and 82. - Apply the parking brake (hand brake) if not already set. The gear selector (automatic transmission) is locked in the ( P)ark position ( SHIFTLOCK ). Manual transmission: the clutch must be fully depressed. - Without touching the accelerator pedal, turn the ignition key 1 to the starting position. Allow the starter to operate for up to 10 seconds. Release the key as soon as the engine starts. If the engine fails to start, repeat this step. NOTE: If the key blade section of the remote is not fully folded out when starting the vehicle, the immobilizer function may make it impossible to start the engine. After a cold start, idle speed may be noticeably higher than normal for a short period. This is done to help bring components in the emission control system to their normal operating temperature as quickly as possible, which enables them to control emissions and help reduce the vehicle's impact on the environment. For cold starts at altitudes above 6000 ft (1800 meters), depress the accelerator pedal halfway and turn the key to the starting position. Release the pedal slowly when the engine starts. - To release the gear selector from the ( P)ark position, the engine must be running (or the ignition key must be in position II) and the brake pedal must be depressed. - Select the desired gear. The gear engages after a very slight delay which is especially noticeable when selecting R. NOTE : Your vehicle is equipped with a KEYLOCK system (automatic transmission). When the engine is switched