2009 Yamaha Motorsports RS Vector GT Owners Manual - Page 52
2009 Yamaha Motorsports RS Vector GT Manual
Page 52 highlights
Periodic maintenance and adjustment To change the engine oil (with or without oil filter cartridge replacement) 1. Place the snowmobile on a level surface and apply the parking brake. 2. Start the engine, warm it up for several minutes, and then turn it off. 3. Remove the shroud, the right side cover, and the top cover. (See page 38 for removal procedures.) 4. Remove the right lower cover and the bottom panel. 1. Oil filler cap 2. Dipstick TIP The engine oil should be between the "H" and "L" level marks on the dipstick. 1. Right lower cover 1. "H" level mark 2. "L" level mark 6. 7. 8. 9. If the engine oil is below the "L" level mark, add sufficient oil of the recommended type to raise it to the "H" level mark. (See page 72 for the recommended oil.) NOTICE: When adding the engine oil, be careful not to fill above the "H" level mark on the dipstick. Use only the recommended oil. (See page 72.) Make sure that no foreign material enters the engine oil tank. [ECS00462] Insert the dipstick into the oil filler hole, and then tighten the oil filler cap. Connect the oil level gauge coupler. Install the right side cover and the shroud. 1 1. Bottom panel 5. 6. Place an oil pan under the oil tank to collect the used oil. Disconnect the oil level gauge coupler. 46