2010 Yamaha Motorsports Apex Owners Manual - Page 52
2010 Yamaha Motorsports Apex Manual
Page 52 highlights
Periodic maintenance and adjustment ESU11741 Tool kit The service information included in this manual and the tools provided in the owner's tool kit are intended to assist you in the performance of preventive maintenance and minor repairs. However, additional tools such as a torque wrench may be necessary to perform certain maintenance work correctly. Shroud To remove the shroud Loosen the fasteners, slowly raise the shroud, and then unhook the shroud from the shroud stay. 1 2 3 1. Fastener 2. Shroud 3. Shroud stay 1. Tool kit ECS00360 NOTICE Before starting the engine, make sure that the tool kit is properly seated in its holder and is securely fastened. To install the shroud Hook the end of the shroud onto the shroud stay, slowly lower it to the original position, and then tighten the fasteners. TIP If you do not have a torque wrench available during a service operation requiring one, take your snowmobile to a Yamaha dealer to check the torque settings and adjust them if necessary. 1. Shroud stay ESU12894 Removing and installing the shroud and covers EWS00091 Left and right side covers To remove a side cover 1. Remove the shroud. (See the above procedure.) 2. Loosen the fasteners, and then remove the side cover. WARNING Be sure shroud and covers are secured before operation. A loose shroud or cover could move and cause loss of control. 46