2010 Yamaha Motorsports FX Nytro MTX Owners Manual - Page 30
2010 Yamaha Motorsports FX Nytro MTX Manual
Page 30 highlights
Control functions 1 2 3 1. Air valve 2. Hose connector 3. Hose connector lock lever 1. Bleed valve button TIP If the shock absorber has no air pressure, the gauge reading will be zero. 5. To increase the air pressure, operate the pump a few times. The pressure should increase slowly. If the pressure increases rapidly, check to make sure that the pump is properly connected and tightened onto the air valve. To decrease the air pressure, push the black bleed valve button. NOTICE: Do not exceed 1034 kPa (10.3 kgf/cm², 150 psi). [ECS00732] Air pressure range: 345 kPa (3.4 kgf/cm², 50 psi) to 1034 kPa (10.3 kgf/cm², 150 psi) Recommended air pressure: 483 kPa (4.8 kgf/cm², 70 psi) TIP To allow pressure to escape from the pump and the shock absorber, push the button halfway down and hold it. To allow only a small amount of pressure to escape, push the button all the way down and quickly release it. 6. Push the hose connector lock lever down, and then remove the hose connector from the air valve. TIP When removing the connector, the sound of air escaping may be heard, but this is from the pump hose, not the shock absorber. 1 7. 30 70 20 80 100 10 0 90 50 60 40 psi Install the air valve cap. TIP If the front shock absorber bottoms too easily or rolls too much during cornering, increase the air pressure by 34 kPa (0.3 kgf/cm², 5 psi). If the shock absorber is too firm and you want a more compliant ride, decrease the air pressure by 34 kPa (0.3 kgf/cm², 5 psi). 1. Pressure gauge (low-pressure meter) 24