2010 Yamaha Motorsports FX Nytro RTX Owners Manual - Page 41
2010 Yamaha Motorsports FX Nytro RTX Manual
Page 41 highlights
Operation G Bare pavement Other surfaces that should be avoided for the sake of drive track and slide runner life are: G Glare ice surfaces G Snow mixed with a lot of dirt and sand All of the above surfaces have one thing in common in regard to drive track and slide runners: little or no lubricating ability. Drive track and all slide rail systems require lubrication (snow or water) between the slide runners and the slide metal. In the absence of lubrication, the slide runners will rapidly wear and in severe cases, literally melt away, and the drive track will be subject to damage or failure. Also traction aids such as studs, cleats, etc., may cause further track damage or failure. EWS00280 severe damage. Do not overtighten the drive track, otherwise it may increase the friction between the track and the slide runners, resulting in the rapid wear of both components. Also, this may put an excessive load on the suspension components, resulting in component failure. Marginal snow The drive track and the slide runners are lubricated and cooled by snow and water. To prevent the drive track and slide runners from overheating, avoid sustained high-speed usage in areas such as icy trails, frozen lakes and rivers that have minimal snow coverage. An overheated track will be weakened internally, which may cause failure or damage. Off-trail riding Avoid off-trail riding until there is sufficient snow coverage. It generally takes several feet of snow to provide a good overall base to properly cover debris, such as rocks, logs, etc. If snow coverage is not sufficient, stay on trails to avoid impact damage to the drive track. WARNING Drive track damage or failure could result in loss of braking ability and snowmobile control, which could cause an accident. G Always check the drive track for damage or maladjustment before operating the snowmobile. G Do not operate the snowmobile if you find damage to the drive track. ECS00350 Studded track In general, track life will be shortened when studs are installed. Drilling stud holes into the drive track will cut the internal fibers, which weakens the track. Avoid spinning the drive track. Studs may catch on an object and pull out of the track, leaving tears and damage around the already weakened area. To minimize possible damage, consult your stud manufacturer for installation and stud pattern recommendations. Yamaha does not recommend track studding. NOTICE Ride on fresh snow frequently. Operating on ice or hard-packed snow will rapidly wear the slide runners. ESU11350 Maximizing drive track life Recommendations Track tension During initial break-in, the new drive track will tend to stretch quickly as the track settles. Be sure to correct the track tension and alignment frequently. (See page 61 for adjustment procedures.) A loose track can slip (ratchet), derail or catch on suspension parts causing 35