2010 Yamaha Motorsports Grizzly 125 Automatic Owners Manual - Page 76
2010 Yamaha Motorsports Grizzly 125 Automatic Manual
Page 76 highlights
1 2 3 4 5 6 7 8 9 10 11 2. Clean the surface of the spark plug gasket and its mating surface, and then wipe off any grime from the spark plug threads. 3. Install the spark plug with the spark plug wrench, and then tighten it to the specified torque. Tightening torque: Spark plug: 12.5 Nm (1.3 m·kgf, 9.0 ft·lbf) To check the engine oil level 1. Place the ATV on a level surface. 2. Check the engine oil level on a cold engine. TIP If the engine was started before checking the oil level, be sure to warm up the engine sufficiently, and then wait at least ten minutes until the oil settles for an accurate reading. 3. Remove the engine oil filler cap, and then wipe the engine oil dipstick off with a clean rag. TIP If a torque wrench is not available when installing a spark plug, a good estimate of the correct torque is 1/4-1/2 turn past finger tight. However, the spark plug should be tightened to the specified torque as soon as possible. 4. Install the spark plug cap. EBU23266 1 2 Engine oil The engine oil level should be checked before each ride. In addition, the oil must be changed at the intervals specified in the periodic maintenance and lubrication chart. 1. Engine oil filler cap 2. Dipstick 8-10