2010 Yamaha Motorsports Grizzly 350 Auto. 4x4 IRS Owners Manual - Page 88
2010 Yamaha Motorsports Grizzly 350 Auto. 4x4 IRS Manual
Page 88 highlights
Tightening torque: Spark plug: 17.5 Nm (1.75 m·kgf, 12.7 ft·lbf) TIP If a torque wrench is not available when installing a spark plug, a good estimate of the correct torque is 1/4-1/2 turn past finger tight. However, the spark plug should be tightened to the specified torque as soon as possible. 3. Install the spark plug cap. EBU23317 TIP If the engine was started before checking the oil level, be sure to warm up the engine sufficiently, and then wait at least ten minutes until the oil settles for an accurate reading. 3. Remove the engine oil filler cap, and then wipe the engine oil dipstick off with a clean rag. Engine oil and oil filter cartridge 8 The engine oil level should be checked before each ride. In addition, the oil must be changed and the oil filter cartridge replaced at the intervals specified in the periodic maintenance and lubrication chart. 1. Engine oil filler cap To check the engine oil level 1. Place the ATV on a level surface. 2. Check the engine oil level on a cold engine. 4. Insert the dipstick into the filler hole (without screwing it in), and then remove it again to check the oil level. 8-12