2011 Yamaha Motorsports Phazer M-TX Owners Manual - Page 23
2011 Yamaha Motorsports Phazer M-TX Manual
Page 23 highlights
Control functions The drive guard is located behind the left side cover. (See page 50 for removal procedures.) To remove the drive guard 1. Pull out the drive guard locking pin from the drive guard rear holder. 1 1. Pull out. 2. Slide to "REV" (reverse). 3. Push in. ECS00072 2 NOTICE Do not use the shift lever while the snowmobile is moving, otherwise the drive train could be damaged. ESU12735 1. Drive guard 2. Drive guard locking pin 2. Drive guard EWS00402 Lift up the rear of the drive guard as shown, and then pull the guard rearward to remove it. WARNING G G Coming in contact with the rotating Vbelt or clutch parts can cause severe injury or death. Never run the engine with the drive guard removed. Make sure that the drive guard is installed securely before operating the snowmobile to protect against severe injury or death from a broken V-belt or other part should it come off the snowmobile while it is in operation. To install the drive guard 1. Fit the front slots in the drive guard over the projections on the drive guard front holder. ECS00830 NOTICE Never run the engine with the V-belt removed. Clutch components can be damaged. The drive guard is designed to protect the Vbelt clutch and V-belt in case parts break or come loose. 17