2012 Yamaha Motorsports Venture Lite Owners Manual - Page 19
2012 Yamaha Motorsports Venture Lite Manual
Page 19 highlights
Control functions Odometer, tripmeter, and engine speed meter modes 1 1. High beam indicator light " ESU10473 " 1. Odometer/tripmeter/engine speed meter Pushing the "SELECT" button switches the display between the odometer mode "ODO", tripmeter mode "TRIP", and engine speed meter mode "r/min" in the following order: ODO → TRIP → r/min → ODO To reset the tripmeter, push the "RESET" button for at least 1 second while the tripmeter is displayed. Low coolant temperature indicator light " " The low coolant temperature indicator light comes on when the coolant temperature is low and informs the rider that the snowmobile should be warmed up. After the engine is started, warm it up until the indicator light goes off. The snowmobile can be operated normally after the indicator light goes off. TIP G G To switch the speedometer, odometer, and tripmeter displays between kilometers and miles, select the odometer mode "ODO", and then push the "SELECT" button for at least 10 seconds while the snowmobile is stopped. Use the engine speed meter only when checking the snowmobile and performing basic maintenance. The engine speed meter should not be used while riding the snowmobile since the reading will vary from the actual engine speed. 1. Low coolant temperature indicator light " " TIP Drive the snowmobile at low speeds when the low coolant temperature indicator light is on. If the engine speed is too high, maximum engine speed is reduced to protect the engine. ESU10411 High beam indicator light " " The high beam indicator light comes on when the high beams of the headlights are switched on. (See page 18 for headlight beam switch operation.) 13