2012 Yamaha Motorsports Venture Lite Owners Manual - Page 66
2012 Yamaha Motorsports Venture Lite Manual
Page 66 highlights
Periodic maintenance and adjustment 9. Place an oil pan under the engine to collect the used oil. 10. Remove the engine oil drain bolt and its gasket to drain the oil from the crankcase. only the recommended oil. (See page 83.) Make sure that no foreign material enters the engine oil tank. [ECS00462] 2 1. "H" level mark 2. "L" level mark 1. Engine oil drain bolt (crankcase) 2. Gasket TIP Dispose of used oil according to local regulations. 11. Install the engine oil drain bolts and their new gasket, and then tighten the bolts to the specified torques. Tightening torques: Engine oil drain bolt (crankcase): 30 Nm (3.0 m·kgf, 22 ft·lbf) Engine oil drain bolt (oil tank): 16 Nm (1.6 m·kgf, 12 ft·lbf) 12. Add 1.5 L (1.59 US qt, 1.32 Imp.qt) of the recommended engine oil to the oil tank, and then install and tighten the oil filler cap. 13. Start the engine, warm it up for several minutes, and then turn it off. 14. Remove the oil filler cap, and then add sufficient oil of the recommended type to raise it to the "H" level mark on the dipstick. NOTICE: When adding the engine oil, be careful not to fill above the "H" level mark on the dipstick. Use Recommended engine oil: See page 83. Oil quantity: With oil filter cartridge replacement: 2.6 L (2.78 US qt, 2.31 Imp.qt) Without oil filter cartridge replacement: 2.4 L (2.59 US qt, 2.16 Imp.qt) Total amount: 3.0 L (3.17 US qt, 2.64 Imp.qt) 15. Install and tighten the oil filler cap. 16. Start the engine, and then let it idle for several minutes while checking it for oil leakage. If oil is leaking, immediately turn the engine off and make sure that the engine oil drain bolt, the oil tank drain bolt, and the oil filler cap are installed correctly. 17. Turn the engine off, and then connect the oil level gauge coupler. 18. Install the right lower cover by installing the bolts. 19. Install the bottom panel by installing the bolts. 20. Install the right side cover (PZ50RT / PZ50GT / PZ50MT), or install the right side cover and the right upper cover, and then close the shroud (PZ50VT). 60