3Ware 3W-7810 User Guide - Page 26
Installing a Parallel ATA RAID Controller
View all 3Ware 3W-7810 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
3ware Hardware Installation 6 Gently remove the ATA RAID Controller from the PCI slot. 7 Remove the cables from the ATA RAID Controller and discard. Reusing interface cables is not recommended. Installing a Parallel ATA RAID Controller Note: If you are not installing a Parallel ATA RAID Controller, continue to page 21 "Installing a Serial ATA RAID Controller". JP2 LED drive status connector Note: Pin 1 and 4 are 3.3V and pin 2 and 3 are ground Plug cable to either pins 1 and 2 or pins 3 and 4. Ports: 65 4 7 3 21 0 0 Serial Number (on plate) Figure 5. 8-Port Escalade 750x-8 ATA RAID Controller Layout Note: The LED drive status connector, if used, will flash for any I/ O activity on any port. Connect the interface cables to the Escalade ATA RAID Controller 1 Connect the interface cables supplied with the product to the ATA RAID Controller. See Figure 5. 18 3ware Escalade ATA RAID Controller User Guide