3Ware RDC-TRAY Quick Start Guide - Page 3

See figure 3. 5. Insert the hard drive into the disk tray. 6. Install the mounting screws on each side to secure the drive in the disk tray. 7. Slide the tray into a slot until it clicks into place. 8. Insert the key (included in your package) into the keylock located on the right of the front panel and turn it clockwise. This will lock the disk tray into the subsystem providing data security and provide power to the drive. If you are replacing a hard drive, make sure to unlock it by turning the key counter-clockwise. NOTE: When the hard drive is being accessed, the HDD activity LED illuminates. Hot Add/Removing Disk The cage supports 'Hot add and remove' by turning power off to the drive when the key is moved to the unlock position. See your controller documentation for whether or not it supports this feature and for the specific procedure to accomplish this. Specifications Form-factor No. of drive channels Hot-swap drive tray Cooling fan Security locks Host independent 5.25" x 3 standard half height drive bays internal mounting 4 4 each 1" trays 2 Yes Yes 720-0091-00 B QUICK START GUIDE, 3W-RDC-400 Rev March 2003 Downloaded from www.Manualslib.com manuals search engine Page 3 of 4