AEG F67732W0P Product Manual - Page 18
The washing and drying results are not satisfactory
![]() |
View all AEG F67732W0P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
18 www.aeg.com Problem and alarm code You cannot activate the appliance. The programme does not start. The appliance does not fill with water. The display shows . The appliance does not drain the water. The display shows . The anti-flood device is on. The display shows . Possible solution • Make sure that the mains plug is connected to the mains socket. • Make sure that there is no damaged fuse in the fuse box. • Make sure that the appliance door is closed. • Press Start. • If the delay start is set, cancel the setting or wait for the end of the countdown. • The appliance has started the procedure to recharge the resin inside the water softener. The duration of the procedure is approximately 5 minutes. • Make sure that the water tap is open. • Make sure that the pressure of the water supply is not too low. For this information, contact your local water authority. • Make sure that the water tap is not clogged. • Make sure that the filter in the inlet hose is not clogged. • Make sure that the inlet hose has no kinks or bends. • Make sure that the sink spigot is not clogged. • Make sure that the drain hose has no kinks or bends. • Close the water tap and contact an Authorised Service Centre. Once you have checked the appliance, deactivate and activate the appliance. If the problem occurs again, contact an Authorised Service Centre. For alarm codes not described in the table, contact an Authorised Service Centre. 12.1 The washing and drying results are not satisfactory Problem Possible solution There are whitish streaks or bluish layers on glasses and dishes. • The release quantity of rinse aid is too much. Adjust the rinse aid selector to a lower position. • The quantity of detergent is too much. There are stains and dry water • The released quantity of rinse aid is not sufficient. Ad- drops on glasses and dishes. just the rinse aid selector to a higher position. • The quality of the rinse aid can be the cause. The dishes are wet. • The programme does not have a drying phase or has a drying phase with low temperature. • The rinse aid dispenser is empty. • The quality of the rinse aid can be the cause. • The quality of the multi-tablets can be the cause. Try a different brand or activate the rinse aid dispenser and use rinse aid and multi-tablets together.
![](/manual_guide/products/aeg-f67732m0p-product-manual-75931db/18.png)