AEG HK614010BB Product Manual - Page 5

Installation instructions 5 WARNING! If there is a crack on the surface, disconnect power supply to prevent the electrical shock. INSTALLATION INSTRUCTIONS Before the installation, note down the serial number (Ser. Nr.) from the rating plate.The rating plate of the appliance is on its lower casing. HK614010BB 949 595 127 00 58 PEE 05 AO 220-240 V 50-60-Hz 6,4 kW AEG The Safety Instructions WARNING! You must read these! Make sure that the appliance is not damaged because of transportation. Do not connect a damaged appliance. If it is necessary, speak to the supplier. Only an authorised servicing technician can install, connect or repair this appliance. Use only original spare parts. Only use the built-in appliances after you assemble the appliance into correct built-in units and work surfaces that align to the standards. Do not change the specifications or change this product. Risk of injury and damage to the appliance. Fully obey the laws, ordinances, directives and standards in force in the country where you use the appliance (safety regulations, recycling regulations, electrical safety rules etc.)! Keep the minimum distances to other appliances and units! Install shock protection, for example install the drawers only with a protective floor directly below the appliance! Keep safe the cut surfaces of the worktop from moisture with a correct sealant! Seal the appliance to the work top with no space between with a correct sealant! Keep safe the bottom of the appliance from steam and moisture, e.g. from a dishwasher or oven! Do not install the appliance adjacent to doors and below windows! If not, when you open the doors or windows they can push off hot cookware from the appliance. WARNING! Risk of injury from electrical current. Carefully obey the instructions for electrical connections. • The electrical mains terminal is live. • Make electrical mains terminal free of voltage. • Install correctly to give shock protection. • Loose and incorrect plug and socket connections can make the terminal become too hot. • A qualified electrician must install the connections in the clamps correctly. • Use a strain relief clamp on cable.