AEG IKE64450FB User Manual - Page 14

14 www.aeg.com • Use a special scraper for the glass. 6.2 Cleaning the hob • Remove immediately: melted plastic, plastic foil, sugar and food with sugar, otherwise, the dirt can cause damage to the hob. Take care to avoid burns. Use a special hob scraper on the glass surface at an acute angle and move the blade on the surface. • Remove when the hob is sufficiently cool: limescale rings, water rings, fat 7. TROUBLESHOOTING stains, shiny metallic discoloration. Clean the hob with a moist cloth and a non-abrasive detergent. After cleaning, wipe the hob dry with a soft cloth. • Remove shiny metallic discoloration: use a solution of water with vinegar and clean the glass surface with a cloth. WARNING! Refer to Safety chapters. 7.1 What to do if... Problem Possible cause Remedy You cannot activate or operate the hob. The hob is not connected to an electrical supply or it is connected incorrectly. Check if the hob is correctly connected to the electrical supply. Refer to the connection diagram. The fuse is blown. Make sure that the fuse is the cause of the malfunction. If the fuse is blown again and again, contact a qualified electrician. You do not set the heat setting for 10 seconds. Activate the hob again and set the heat setting in less than 10 seconds. You touched 2 or more sen- Touch only one sensor field. sor fields at the same time. Pause operates. Refer to "Daily use". There is water or fat stains on the control panel. Clean the control panel. An acoustic signal sounds You put something on one and the hob deactivates. or more sensor fields. An acoustic signal sounds when the hob is deactivated. Remove the object from the sensor fields. The hob deactivates. You put something on the sensor field . Remove the object from the sensor field.