AEG IKE64450FB User Manual - Page 15

ENGLISH 15 Problem Possible cause Remedy Residual heat indicator does not come on. The zone is not hot because it operated only for a short time or the sensor is damaged. If the zone operated sufficiently long to be hot, speak to an Authorised Service Centre. Automatic Heat Up does not The zone is hot. operate. Let the zone become sufficiently cool. The highest heat setting is set. The highest heat setting has the same power as the function. The heat setting changes between two levels. Power management operates. Refer to "Daily use". The sensor fields become hot. The cookware is too large or Put large cookware on the you put it too near to the rear zones if possible. controls. There is no sound when you The sounds are deactivated. Activate the sounds. Refer to touch the panel sensor "Daily use". fields. comes on. Child Safety Device or Lock Refer to "Daily use". operates. comes on. There is no cookware on the Put cookware on the zone. zone. The cookware is unsuitable. Use suitable cookware. Refer to "Hints and tips". The diameter of the bottom Use cookware with correct of the cookware is too small dimensions. Refer to "Tech- for the zone. nical data". and a number come on. There is an error in the hob. Deactivate the hob and activate it again after 30 sec- onds. If comes on again, disconnect the hob from the electrical supply. After 30 seconds, connect the hob again. If the problem continues, speak to an Authorised Service Centre. You can hear a constant beep noise. The electrical connection is incorrect. Disconnect the hob from the electrical supply. Ask a qualified electrician to check the installation.