AEG L8FBE961R User Manual - Page 14
Stains/Prewash, Plus Steam, Delay Start
View all AEG L8FBE961R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
14 www.aeg.com The display shows the indicator . The door stays locked. The drum turns regularly to reduce creasing. You must drain the water to unlock the door. As the programme is very quiet, it is suitable for use at night time when cheaper electricity tariffs are available. In some programmes the rinses are performed with more water. If you touch the Start/Pause button, the appliance performs the only draining phase. The appliance empties the water out automatically after 18 hours approximately. • Drain only option (Skipping the wash, rinse and spin phases) . The appliance performs the only draining phase of the selected washing programme. The display shows the indicator (cold), and the indicator (no spin) and the indicator . • Spin only option (Skipping the wash and rinse phases) . The appliance performs only the spinning phase of the selected washing programme. The display shows the indicator (cold), the phase indicator and the spin speed. If it is necessary to reduce the spin speed, select a programme with a lower spin speed as default. 6.5 Stains/Prewash Press this button repeatedly to activate one of the two options or both. The relevant indicator goes on in the display. • Stains Select this option to pre-treat heavily soiled or stained laundry using stain remover. Pour the stain remover into compartment . The stain remover is pre-mixed and heated with detergent in order to improve its effectiveness. This option is not available with a temperature lower than 40 °C. • Prewash Use this option to add a prewash phase at 30 °C before the washing phase. This option is recommended for heavily soiled laundry, especially if containing sand, dust , mud and other solid particles. The options can increase the programme duration. 6.6 Plus Steam This option adds a steam phase followed by a short anti-crease phase at the end of the washing programme. The steam phase reduces fabric creasing and facilitates the fabric ironing. The indicator flashes on the display during steam phase. This option can increase the programme duration. When the programme stops the display shows a zero , the indicator is steady on and the indicator starts flashing. The drum performs smooth movements for about 30 minutes to keep the steam benefit. By touching any button the anti-crease movements stop and the door unlocks. A small laundry load helps to reach better results. 6.7 Delay Start With this option you can delay the start of a programme in a more convenient time. Touch the button repeatedly to set the required delay. The time increases by steps of 30 minutes up to 90' and from 2 hours up to 20 h.