AEG T35850 Product Manual - Page 14
Troubleshooting by yourself - fuse
View all AEG T35850 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
14 What to do if ... What to do if ... Troubleshooting by yourself Problem Possible cause Remedy Dryer does not work. Mains plug is not plugged in or fuse is not working correctly. Plug in at mains socket. Check fuse in fuse box (domestic installation). Loading door is open. Close loading door. Have you pressed the START Press the START PAUSE button PAUSE button? again. Wrong programme selected. Select a different programme the next time you dry (see "Programme chart" chapter). Filter clogged. Clean filter. Drying results unsatisfactory. Overloading of laundry. Ventilation slots covered up. Observe recommended loading volumes. Uncover ventilation slots. Residue on inside surface of Clean inside surface of drum drum or drum ribs. and drum ribs. Conductance of water at installation site differs from standard setting of machine. Re-programme standard setting for degree of drying (see 'Programming options' chapter). Loading door does not close. Filter not in place. Install filter into place. Drum light does not work. Programme selector in OFF po- Turn programme selector to sition. LIGHT or to any programme. Defective light bulb. Replace light bulb (see next section). Drying cycle ends shortly after programme starts. Not enough washing loaded or washing loaded is too dry for selected programme. Select time programme or higher drying level (e.g. EXTRA DRY instead of STORAGE DRY). Filter clogged. Clean filter. Drying cycle lasts an unusually long time. Note: After around 5 hours the drying cycle ends automatically. Load volume too big. Laundry insufficiently spun. Particularly high room temperature. Temporary switching off of the compressor to avoid overload. Reduce load volume. Laundry must be adequately spun. Automatic process, there is no fault with the appliance. If possible, lower the room temperature.