AEG T76280AC Product Manual - Page 18

18 www.aeg.com Problem1) Unsatisfactory drying results. The door does not close. Err (Error) on the display. No drum light 5) Abnormally elapsing time on the display.) Programme inactive. Possible cause Remedy The loading door is opened. Close the loading door. The On/Off button was not pushed. Push the On/Off button. The Start/Pause button was not pushed. Push the Start/Pause button. The appliance is in the standby mode. Push the On/Off button. Incorrect programme selection. Do the selection of the applicable programme. 2) The filter is clogged. Clean the filter. 3) The Dry Plus function was in minimum mode. Change the Dry Plus function to the moderate or maximum mode. The condenser is clogged. Clean the condenser. 3) Too high volume of the load. Obey the maximum load volume. The airflow grill is clogged. Clean the airflow grill in the bottom of the appliance. Dirt on the inner surface of the Clean the inner surface of the drum. drum. Too high water hardness. Set applicable water hardness4). The filter not locked in the po- Put the filter in the correct posi- sition. tion. The laundry is locked between Put the load correctly in the the door and the seal. drum. You try to change the programme or the function after the start of the cycle. Turn the tumble dryer off and on. Make the new selection. The function you try to activate is not applicable with the selected programme. Turn the tumble dryer off and on. Make the new selection. Defective drum light. Contact the service centre to replace the drum light. The time to end is calculated The automatic procedure - on the basis of the volume and this is not the appliance mal- dampness of the laundry. function. The water container is full. Drain the water container3) , push the Start/Pause button.