AIWA CDC-R304 Operating Instructions - Page 4

GETTING STARTED Note Some buttons on the unit are assigned two or more functions. For detailed descriptions, refer to the related pages. Resetting the unit Before operating the unit for the first time, or after replacing the car battery or changing the connections, you must reset the unit. Remove the front panel and press the reset button with a pointed object, such as a ballpoint pen. Front panel detached Reset button Note Pressing the reset button will erase the clock and some memorized functions. DEMO (demonstration) mode The unit has an extra display (DEMO) mode which demonstrates the illumination modes of the unit. When you deactivate the unit by pressing (OFF), the clock is displayed for about 10 seconds, then the unit switches to DEMO mode. To cancel DEMO mode 1 While in DEMO mode, press and hold (PUSH-MENU) until "SET" appears on the display. 2 Press (SEEK) (+) or (SEEK) (-) to select "DEMO." 3 Turn (PUSH-MENU) to select "DEMO OFF." To resume DEMO mode, repeat the above and select "DEMO ON" at step 2. Theft protection Take the front panel with you when leaving the car, and keep it in the supplied carrying case. Caution alarm If you turn off the ignition switch to the OFF position without removing the front panel, the caution alarm will beep for a few seconds. If you connect an optional amplifier and do not use the built-in amplifier, the beep tone will be deactivated. To detach the front panel 1 Press to remove the disc. 2 Press (OFF) * . 3 Press it, then pull it off towards you. (Hold the panel with one hand to prevent accidentally dropping it.) (OFF) rFn4i * If your car has no ACC position on the ignition switch, be sure to turn the unit off by pressing (OFF) until the display disappears to avoid car battery drain. To attach the front panel 1 Engage the right side of the front panel to the right catch on the unit. 2 Push the panel forward until it locks. Be sure not to press any buttons and the display window. 2 Notes • If you detach the panel while the unit is still turned on, the power will turn off automatically to prevent the speakers from being damaged. • Do not subject the front panel to heat/high temperature or moisture. Avoid leaving it in a parked car or on a dashboard/rear tray. • Do not put anything on the inner surface of the front panel. 4