AIWA XP-SP911 Operating Instructions - Page 6

M PHONES/ LINE OUT N O Use a commercially available connection cord which has a 3.5ø stereo mini lug at one end and two phono plugs at the other end. Connect the stereo mini-plug to the PHONES/LINE OUT jack of the unit and connect the phono plugs to the analog input terminals of the external unit. Note • Turn off the power of both units before connection. • DO NOT connect to the PHONO inputs of an amplifier (with a built-in phonoequalizer-amplifier). • Adjust the volume and DSL on this unit. MAINTENANCE To clean the lens → N If the lens becomes dirty, the player will skip or not play. If this occurs, clean the lens in the following manner. To remove dust or dry particles, first use a camera lens blower/brush a to blow a few times to loosen particles, then gently brush the lens b clean. Finish by blowing the lens again. To remove fingerprints, use a cotton swab dipped in lens cleaning solution. Wipe gently from the center to the edge. Lens cleaning solution is commercially available. Note Take care not to get too much solution on the swab, which could flow into the unit and cause damage. Pressing too strongly with the swab could scratch or break the lens. To clean the discs → O Before playing, wipe the disc from the center outward with a cleaning cloth. After playing, store the disc in its case. SPECIFICATIONS Tracking system 3-beam laser Laser pickup Semiconductor laser D/A conversion 4-times oversampling digital filter + 1-bit DAC Frequency response 20 - 20,000 Hz (47 k ohms) Output PHONES/LINE OUT jack (stereo mini-jack) Maximum output 12 mW + 12 mW (16 ohms at 1 kHz) 500 mV (47 k ohms at 1 kHz) Power supply DC 3 V using two size AA (LR6) alkaline batteries DC 2.4 V using commercially available rechargeable batteries AC house current using the supplied AC adaptor Maximum outside dimensions 132 (W) × 30 (H) × 141 (D) mm (excluding projecting parts and controls) (5 1/4 × 1 3/16 × 5 5/8 in.) Weight Approx. 270 g (9.5 oz.) excluding batteries Accessories AC adaptor AC-D603 (1) Stereo headphones (1) Carrying case (XP-SP911 only) (1) AC adaptor AC-D603 Rated input: AC 120 V, 60 Hz The specifications and external appearance of this unit are subject to change without notice.