ASRock 890GMH/USB3 User Manual - Page 25
Onboard Headers and Connectors
View all ASRock 890GMH/USB3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
2.8 Onboard Headers and Connectors Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard! • Floppy Connector (33-pin FLOPPY1) (see p.12 No. 26) Pin1 FLOPPY1 the red-striped side to Pin1 Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the connector. Primary IDE connector (Blue) (39-pin IDE1, see p.12 No. 10) PIN1 IDE1 connect the blue end connect the black end to the motherboard to the IDE devices 80-conductor ATA 66/100/133 cable Note: Please refer to the instruction of your IDE device vendor for the details. Serial ATAII Connectors These five Serial ATAII (SATAII) (SATAII_1 (PORT 0): connectors support SATAII see p.12, No. 20) or SATA hard disk for internal (SATAII_2 (PORT 1): storage devices. The current see p.12, No. 19) SATAII interface allows up to (SATAII_3 (PORT 2): 3.0 Gb/s data transfer rate. see p.12, No. 18) SATAII_1 SATAII_2 SATAII_3 SATAII_4 SATAII_5 (SATAII_4 (PORT 3): (PORT 0) (PORT 1) (PORT 2) (PORT 3) (PORT 4) see p.12, No. 17) (SATAII_5 (PORT 4): see p.12, No. 16) Serial ATA (SATA) Data Cable (Optional) Either end of the SATA data cable can be connected to the SATA / SATAII hard disk or the SATAII connector on the motherboard. 25