ASRock 960GC-GS FX Quick Installation Guide - Page 14

1.6 Onboard Headers and Connectors Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard! Floppy Connector (33-pin FLOPPY1) (see p.2 No. 20) the red-striped side to Pin1 Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the connector. Primary IDE connector (39-pin IDE1, see p.2 No. 6) connect the blue end to the motherboard connect the black end to the IDE devices 80-conductor ATA 66/100/133 cable Note: Please refer to the instruction of your IDE device vendor for the details. Serial ATA2 Connectors (SATAII_1 (PORT 0): see p.2, No. 14) (SATAII_2 (PORT 1): see p.2, No. 15) (SATAII_3 (PORT 2): see p.2, No. 12) (SATAII_4 (PORT 3): see p.2, No. 11) (SATAII_5 (PORT 4): SATAII_2 (PORT 1) see p.2, No. 10) (SATAII_6 (PORT 5): SATAII_1 (PORT 0) see p.2, No. 9) These six Serial ATA2 (SATA2) connectors support SATA data cables for internal storage devices. The current SATA2 interface allows up to 3.0 Gb/s data transfer rate. SATAII_6 (PORT 5) SATAII_4 (PORT 3) SATAII_5 (PORT 4) SATAII_3 (PORT 2) English 14 ASRock 960GC-GS FX Motherboard