Acer AW2000ht-AW170ht F1 Acer AW2000ht w AW170htx F1 Server Service Guide - Page 69

Chapter 8 System diagnositcs This chapter helps you identify and solve problems that might occur while you are using the system. For any issue, first ensure you are using the latest firmware and files. Firmware upgrades include updates for BIOS, the baseboard management controller (BMC), and the hot-swap controller (HSC). In addition to the server firmware and files, also update any drivers used for components you have installed in your system, such as video drivers, network drivers, and SCSI drivers. System Check Procedures Power System Check If the system will power on, skip this section. Refer to System External Inspection. If the system will not power on, check if the power cable is properly connected to the system and AC source. System External Inspection 1. Inspect the LED indicators on the front panel, which can indicate the malfunction. For the LED locations and description of their behaviour, see "Switch and LED indicators" on page 20. 2. Make sure that air flow is not blocked. 3. Make sure nothing in the system is making contact that could short out power. 4. If the problem is not evident, continue with System Internal Inspection. System Internal Inspection 1. Turn off the system and all the peripherals connected to it. 2. Unplug the power cord from the power outlets. 3. Unplug the power cord from the system. 4. Unplug all peripheral cables from the system. 5. Place the system unit on a flat, stable surface. 6. Remove the system cover. For instructions on removing system cover, refer to disassembling steps. 7. Verify that components are properly seated. 8. Verify that all cable connectors inside the system are firmly and correctly attached to their appropriate connectors. 9. Verify that all components are Acer-qualified and supported. 10. Replace the system cover. 11. Power on the system. Chapter 8 63