Acer L811 User Manual - Page 32

LAN IP, Setting, LAN IP/ Mask, LAN Reset, Note 1, projector. If not, perform

Get Acer L811 PDF manuals and user guides View all Acer L811 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

English 22 area network. 2. Open the web browser on your PC and type in the LAN IP of the projector. (See the LAN IP in the Setting > LAN > LAN IP/ Mask menu.) 3. Set a password. Password needs to be at lest 8 characters in length and use a mix of the following 3 types of letters: uppercase letters, lowercase letters and digits. Enter the password a again to confirm it. 4. The remote network operation page displays and you can control the projector. If not, perform LAN Reset in the Setting > LAN menu of the projector's OSD menu and then try again. Note 1 : An overview of the remote network operation page To switch input signals, click your desired signal. See Note 2 and Note 3. These buttons function the same as those on the OSD menus, projector control panel, or remote control. Note 2 : An overview of the Tools page You can enter the projector information. DHCP can be disabled and these settings have to be configured manually. You can set the user password/ administrator password to prevent unauthorized use of the remote network operation/Tools page. Note 3: The Info page shows the projector information and status. Mac Address can be obtained from here.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
22
English
area network.
2. Open the web browser on your PC and type in the LAN IP of the projector.
(See the
LAN IP
in the
Setting
>
LAN
>
LAN IP/ Mask
menu.)
3. Set a password. Password needs to be at lest 8 characters in length and use
a mix of the following 3 types of letters: uppercase letters, lowercase letters
and digits. Enter the password a again to confirm it.
4. The remote network operation page displays and you can control the
projector. If not, perform
LAN Reset
in the
Setting
>
LAN
menu of the
projector’s OSD menu and then try again.
Note 1 :
An overview of the remote network operation page
Note 2 :
An overview of the Tools page
Note 3:
The Info page shows the projector information and status.
To switch input
signals, click your
desired signal.
These buttons
function the
same as those
on the OSD
menus,
projector
control panel,
or remote
control.
See Note 2 and
Note 3.
You can enter
the projector
information.
DHCP can be
disabled and
these settings
have to be
configured
manually.
You can set the
user password/
administrator
password to
prevent
unauthorized use
of the remote
network
operation/Tools
page.
Mac Address
can be
obtained
from here.