Acer TravelMate P633-V Acer TravelMate P633 Series Notebook Service Guide - Page 195

Clearing Password Check and BIOS Recovery 0 This section provides procedures for: Clearing the BIOS passwords Performing a BIOS recovery Clearing the BIOS Passwords 0 To clear a lost BIOS password (user or supervisor password), you need to short the clear password hardware gap (G2201) located on the mainboard. Figure 2-3. G2201 Hardware Gap 1. Shut down the computer and disconnect the AC adapter and all other peripherals from the computer. 2. Remove the battery pack and base door. 3. If the Mini Card slot is occupied, remove the installed wireless module. 4. Locate the G2201 gap. 5. Use an electrical conductivity tool to short the two contacts on the hardware gap together. 6. While resting the tool on the two contacts, plug one end of the AC adapter into the DC-in jack and plug one end to an electrical outlet. 7. Press the button to turn on the computer. 8. After the BIOS POST, remove the tool from the hardware gap. 9. If a wireless module was removed, reinstall it. 10. Reinstall the battery pack and the base door. 11. Turn on the computer and press F2 during bootup to access the Setup Utility. If no password prompt appears, the BIOS passwords have been cleared. If the prompt appears, repeat steps 4-9 until the BIOS passwords have been cleared. 12. Press F9 to load the system defaults. 13. Press F10 to save the changes you made and close the Setup Utility. Jumper and Connector Locations 5-5