Actiontec HPE400T Kit User Manual - Page 8
Connecting the MegaPlug Hub, Connecting the Hubs
View all Actiontec HPE400T Kit manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Connecting the MegaPlug Hub 2 To connect the Hub, it must be connected to a computer, plugged into a standard wall outlet, and the Configuration Utility loaded on the computer. Connecting the Hub To use the Hub properly, if should be plugged into electrical outlets, and devices (computers, printers, etc.) connected to them. Connecting a Hub to a Computer 1. Get a Hub and one Ethernet cable. 2. Insert one end of the Ethernet cable into the Ethernet port of the Hub. 3. Plug the Hub into a wall outlet. ☞ Note: Do not plug the Hub into a UPS or power strip with surge protection. The Hub's network signal may not pass through these devices. 4. Insert the other end of the Ethernet cable into an Ethernet port on the back of a computer. Connecting a Hub to a Router/Gateway 1. Get a Hub and one Ethernet cable. 2. Insert one end of the Ethernet cable into the Ethernet port of the Hub. 3. Plug the Hub into a wall outlet. ☞ Note: Do not plug the Hub into a UPS or power strip with surge protection. The Hub's network signal may not pass through these devices. 4. Insert the other end of the Ethernet cable into an Ethernet port on a router/ gateway connected to a computer. 5