Adaptec 2200S Software Reference Manual - Page 284

Adaptec SCSI RAID Software Reference Guide enclosure set power To turn the power of a specific power supply on a specific SAF-TE enclosure management device on or off, use the enclosure set power command. Typically, most enclosure management devices turn on their associated power supplies by default after power up. Syntax enclosure set power [/off{=boolean}] {enclosure} {powersupply} Parameters {enclosure} Specifies the ID associated with the enclosure management device on which you want to turn the power of a specific power supply on or off. For this version, the controller supports a maximum of eight enclosure management devices on each bus. {powersupply} Specifies the unit number associated with the power supply whose power you want to turn on or off. The unit number for the power supply can range from 0 to 15 inclusive. Switches /off{=boolean} Specifies whether to turn the power supply associated with the specified unit number on or off. If you set this switch to TRUE, the command turns off the power supply associated with the specified unit number. If you specify FALSE, the command turns on the power supply associated with the specified unit number. This switch defaults to FALSE, which means the command turns on the power supply if you do not specify the switch. Examples Before turning a power supply on or off, you might want to use the enclosure show power command to determine the current setting for the power supply or supplies. As the following example 11-20