Adaptec 2420SA User Guide - Page 35
Connecting Disk Drives to SATA RAID Controllers, Connecting External Devices, before
UPC - 760884149331
View all Adaptec 2420SA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Chapter 5: Installing the Controller and Disk Drives ● 35 Connecting Disk Drives to SATA RAID Controllers 1 Install your SATA disk drives, following the instructions in your system's documentation. There are no jumpers or switches to set on the SATA controller or disk drives. 2 Connect each disk drive to a SATA port on the controller using a recommended SATA cable. For cable information, see About Your RAID Controller on page 15. 3 When all internal disk drives have been installed and connected, close your computer cabinet, and reattach the power cord. Continue by either setting the boot controller (see page 37) or by installing the controller driver on an existing operating system (see page 49), depending on the type of installation you are completing. Connecting Disk Drives to SCSI RAID Controllers 1 For each controller channel, set the SCSI ID of each disk drive to a unique number between 0 and 15. The controller is set to ID 7 by default. Although not recommended, you can change the controller ID by using the ARC utility (see page 78). Note: Do not change the controller ID unless absolutely necessary. 2 Install a terminator (or enable termination) on the disk drive at the end of each cable, or the end of the cable itself. Remove any terminators (or disable termination) on disk drives between the ends of each cable. Install your SCSI disk drives, following the instructions in your system's documentation. 3 If space inside your computer cabinet is limited, connect your disk drives to the SCSI cable before installing them. (For installation instructions, refer to your computer's documentation.) ! Caution: To avoid causing unstable operation, do not attach a cable to the controller unless the other end of the cable is attached to a least one disk drive. Alternatively, install your disk drives, then connect them to the controller. 4 When all internal disk drives have been installed and connected, close your computer cabinet, reattach the power cord, then continue with the following section. Connecting External Devices Note: If you are not connecting any external devices, see the following section, Next Steps. 1 (SCSI controllers only) Ensure that SCSI IDs and termination are set before completing the connections to external disk drives or devices. See page 35. 2 Use high-quality cables to connect your controller to your external device(s), such as disk drives or disk drive enclosures. Adaptec recommends using only Adaptec cables. For more information or to purchase cables, visit the Adaptec Web site at www.adaptec.com.