Adaptec 2940 Installation Guide - Page 9

For situations where you might want or need to change the settings, see the descriptions of each setting in the user's guide. If you need to change any of the default settings, or if you would like to format or verify a disk, see Starting the SCSISelect Utility on page 9 to start the utility. Basic Host Adapter Settings Default Host Adapter SCSI ID 7 SCSI Parity Checking Host Adapter SCSI Termination Enabled Automatic1; Low ON/ High ON2 Boot Device Settings Default Boot Target ID 0 Boot LUN Number3 0 SCSI Device Settings Default Initiate Sync Negotiation Yes (Enabled) Maximum Sync Transfer Rate 10 MBytes/sec Enable Disconnection Initiate Wide Negotiation2 Send Start Unit SCSI Command4 Yes (Enabled) Yes (Enabled) No (Disabled) Advanced Host Adapter Settings Default Plug and Play SCAM Support Disabled Host Adapter BIOS Enabled Support Removable Disks Under BIOS as Fixed Disks4 Boot only Extended BIOS Translation for DOS Drives > 1 GByte4 Enabled Display Message During BIOS Initialization4 Enabled Multiple LUN Support4 Disabled BIOS Support for More Than 2 Drives4 Enabled BIOS Support for Bootable CD-ROM4 Enabled BIOS Support for Int 13 Extensions4 Enabled 1 Applies to AHA-2940 only 2 Applies to AHA-2940W only 3 Setting is valid only if Multiple LUN Support is enabled 4 Settings are valid only if host adapter BIOS is enabled. 8 Downloaded from www.Manualslib.com manuals search engine