Adaptec 5325301553 Quick Start Guide - Page 2
Installing the Snap Server 14000 in a Rack, Connecting the Power Cords
![]() |
UPC - 753253015535
View all Adaptec 5325301553 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Installing the Snap Server 14000 in a Rack Install the Snap Server 14000 into a rack using the rack mounting kit provided. Warning: The server weighs approximately 75 pounds, and rack installation requires two or more people. In a 4-post rack, it is highly recommended that you use the rear support brackets to secure the server to the rack. For more information, refer to the Rack Installation Guide or Administrator Guide. Connecting the Power Cords 1. Plug the power cords provided into the server's individual power connectors. 2. Plug the other ends of the power cords into properly grounded electrical outlets. For the greatest protection from power failures, connect each power cord to a different uninterruptible power supply (UPS). Each UPS should have a minimum rating of 160 watt hours. If you have only one UPS, connect one power cord to the UPS. Connect the other power cord to a properly grounded electrical outlet. If you have no UPS available, connect each power cord to a different properly grounded electrical outlet. (Avoid plugging both cords into one multiple-outlet surge protector or one two-socket wall outlet.)
![](/manual_guide/products/adaptec-5325301553-quick-start-guide-7903be1/2.png)