Adaptec AVA1515 Installation Guide - Page 3
Installing the Host Adapter
View all Adaptec AVA1515 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Parameter SCSI Disconnection1 Board Label Default Setting DN Enabled SCSI Address SCSI Parity 1 7 SP Enabled Terminators Installed Terminator Power Interrupt Channel 1 IRQ Channel 1 AT Port Address 1 Host Adapter BIOS1 Host Adapter BIOS Address 1 I09, I10, I11, I12 IC1, IC0 ALT BEN AS1, AS0 Supplied by host adapter 11 11 340h-35Fh Enabled DC000h-DFFFFh 1 See Section 8, Jumper Block Settings, to change these settings. 4 Installing the Host Adapter Setting Jumpers If you need to change jumper block settings, do it now before you replace the chassis cover. See Section 8, Jumper Block Settings, for details. In most cases, you do not have to change the default jumper settings. Here are situations in which you should change the settings: s If you change the default port address by installing the extra jumper on pin pair ALT, you may also need to change options in the software (see Section 6, Software Installation). s If another Adaptec SCSI host adapter is already installed in your computer, you may need to change the interrupt channel and IRQ channel of the AVA-1515. Interrupt and IRQ setting must be the same number. If you change the setting you may also need to change options in the software (see Section 6, Software Installation). Note: If you change the BIOS address, disable the BIOS, because the host adapter BIOS supports booting only from the default port address range. 2