Airlink WLC010 Quick installation guide - Page 2

C. Installing the Wireless LAN Card Software 1. Close all Windows programs that are running. 2. Run Setup.exe from the D:\Utility folder of the Wireless LAN Card Installation CD-ROM where D is the CD-ROM drive letter, and click Next. 3. Click Yes to accept the Software Licensing Agreement. 4. In the SSID box, enter the Service Set ID name of your wireless network, and then click Next. 5. Write down the Service Set ID name exactly as you have entered it (for use in a later installation step), and then click OK 6. Click the Infrastructure if you want your wireless computer to be associated with an access point. Click Ad-Hoc if you want multiple wireless computers to network directly with each, and then click Next. 7. To install the software to the default destination folder, click Next. 8. To install to a different folder, click Browse and select another folder. 9. After Windows copies the Setup files from the CD-ROM, click Yes, I want to restart my computer now, and then click Finish. D. Connecting to Other Wireless LAN Systems (Ad Hoc Only) Connecting directly to one Wireless LAN Card equipped computers 1. In the systray area, click the Wireless LAN Link Status icon to display the Wireless LAN Configuration Utility dialog box. 2. Click the Configuration tab. 3. In the Mode list, click AdHoc. 4. In the SSID list, select the SSID name of the Wireless LAN group. 4. In the Tx Rate list, click Fully Automatic. 5. In the Channel list, select a channel number the same with the channel number used by the connected computer. 6. Click Apply Changes. You should now be able to find your computer on the Network Neighborhood in Windows Explorer. 7. Click OK if you wish to exit the utility. E. Connecting to an Access Point (Infrastructure) Connecting your computer to an Infrastructure network 1. In the systray area, click the Wireless LAN Link Status icon to display the Wireless LAN Configuration Utility dialog box. If the wireless icon does not display in the systray area, click Start -> Programs -> PRISM 802.11 -> Configuration Utility. 2. Click the Configuration tab. 3. In the Mode list, click Infrastructure. 4. In the SSID list, click or enter the SSID name of the Access Point. All wireless clients must use the same SSID in order to communicate with each other. 5. Click Apply Changes. Click on the Link Info Page, you will see the status " Associated-BSSID=xx.xx.xx.xx.xx.xx ". 6. Click OK if you wish to exit the utility. F. Technical Support Email: [email protected] Web: www.airlinkplus.com