Alesis MicroVerb4 User Manual - Page 35

Chapter 4 - Description of Controls Rear Panel Power This is a plug for connecting the Alesis Model P3 +9VAC power supply (supplied). The power supply is then connected to an AC outlet delivering a nominal 120VAC. The correct power supply must be used AT ALL TIMES. Any other power supply might create a fire risk and/or permanently damage your unit. This damage would NOT be covered under your warranty. Footswitch This is a 1/4" stereo phone jack which connects to one or two momentary (not latching) footswitches, either normally-open or normally-closed. • When one footswitch is plugged into the Footswitch jack, it will function as a Bypass footswitch. When the Footswitch is pressed, the display will read "bYP", the display will dim, and the MicroVerb 4 will stop producing effects. If the footswitch is pressed again, effects output will continue. • Two footswitches can be connected if a simple adapter cable is used, similar to an Insert cable: When this setup is used, the footswitch connected to the Tip functions as a Bypass footswitch. The footswitch connected to the Ring functions as a Control footswitch. For more information, see Chapter 2, "Footswitch". MIDI In This is a 5-pin DIN standard MIDI plug which connects to any MIDI compatible equipment such as a MIDI sequencer that will send program changes and controller information to the unit. MIDI Out/Thru This is a 5-pin DIN standard MIDI plug which connects to any MIDI compatible equipment such as a keyboard or another effects device. It is provided for sending system exclusive commands for storing programs. It also relays all messages received on the [MIDI IN]. Input (Left/Mono & Right) 34 MicroVerb 4 Reference Manual