Alpine CDA-117 Owner's Manual (english) - Page 11

Radio Rotary encoder/ENTER/ BAND SOURCE/ /ESC TUNE/A.ME  FUNC. Preset buttons (1 through 6) This unit cannot receive HD Radio signals (digital terrestrial radio). In order to activate the dig tal radio functions described below, an optional HD Radio Tuner module must be connected through the Ai-NET bus. iTunes Tagging lets you tag songs you hear on HD Radio stations with your new CDA-117 and then preview, buy, and download them later from your iTunes Tagged playlist the next time you sync your iPhone/ iPod. If the unit is connected to a Tagging compatible device, you can use the iTunes Tagging function. For details, refer to the Owner's Manual of the Tagging compatible device. Listening to Radio 1 Press SOURCE to select TUNER mode. 2 Press BAND repeatedly until the desired radio band is displayed. FM1  FM2  AM  FM1 3 Press TUNEA.ME to select the tuning mode. DX (Distance mode)  LOCAL (Local mode)  MANUAL (Manual mode)  DX Note • The initial mode is Distance mode. Distance mode: Both strong and weak stations will be automatically tuned in (Automatic Seek Tuning). Local mode: Only strong stations will be automatically tuned in (Automatic Seek Tuning). Manual mode: The frequency is manually tuned in steps (Manual tuning). 4 Press  or  to tune in the desired station. Holding down  or  will change the frequency continuously. Note • If Digital Seek is set to ON, the SEEK UP/DOWN functions only stop on digital station frequencies while receiving an HD Radio signal. Refer to "Digital Seek ON/OFF Setting" on page 25. Presetting Stations Manually 1 Tune in the station you want to store. Press and hold, for at least 2 seconds, any one of the preset buttons (1 through 6) into which you wish to store the station. The display shows the band, preset number and station frequency memorized. Notes • A total of 18 stations can be stored in the preset memory (6 stations for each band; FM1, FM2 and AM). • If you store a station in a preset memory which already has a station, the current station will be cleared and replaced with the new station. • If the (F) indicator is illuminated, turn off the indicator by pressing FUNC., then you can perform the operation. Presetting Stations Automatically 1 Press BAND repeatedly until the desired radio band is displayed. 2 Press and hold TUNEA.ME for at least 2 seconds. The frequency on the display continues to change while the automatic memory is in progress. The tuner will automatically seek and store 6 strong stations in the selected band. They will be stored into preset buttons 1 to 6 in order of signal strength. When the automatic memory has been completed, the tuner goes to the station stored in preset location No.1. Note • If no stations are stored, the tuner will return to the original station you were listening to before the auto memory procedure began. Tuning to Preset Stations 1 Select the desired band, then press any one of the station preset buttons (1 through 6) that has your desired radio station in memory. The display shows the band, preset number and frequency of the station selected. Note • If the (F) indicator is illuminated, turn off the indicator by pressing FUNC., then you can perform the operation. Frequency Search Function You can search for a radio station by its frequency. 1 Press and hold ENTER for at least 2 seconds in Radio mode to activate Frequency search mode. 2 Turn the Rotary encoder to select the desired frequency. 3 Press ENTER to receive the selected frequency.* * Operation is not required during HD Radio reception. Note • Press ESC in the search mode to cancel. Or, the search mode will be canceled if no operation is performed for 10 seconds. 9-EN