Alpine CDA 9856 Owners Manual - Page 32
Installation
UPC - 793276711274
View all Alpine CDA 9856 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Installation 2 Hex Nut (M5) Screw Detachable Front panel Caution When you install this unit in your car, do not remove the detachable front panel. If the detachable front panel is removed during installation, you might press too hard and warp the metal plate that holds it in place. Accessory List • Head unit 1 • Power cable 1 • Mounting sleeve 1 • Carrying case 1 • Bracket key 2 • Screw (M5x8 4 • Owner's Manual 1 set • The main unit must be mounted within 35 degrees of the horizontal plane, back to front. Less than 35° 1 Mounting Sleeve (Included) Dashboard *2 Bolt Stud Metal Mounting Strap *1 Ground Lead Chassis this unit Reinforce the head unit with the metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw (*1) already attached to the vehicle's chassis. • For the screw marked "*2", use an appropriate screw for the chosen mounting location. Connect each input lead coming from an amplifier or equalizer to the corresponding output lead coming from the left rear of the CDA-9856. Connect all other leads of the CDA-9856 according to details described in the CONNECTlONS section. 3 Slide the CDA-9856 into the dashboard until it clicks. This ensures that the unit is properly locked and will not accidentally come out from the dashboard. Install the detachable front panel. Removal 1. Remove the detachable front panel. 2. Insert the bracket keys into the unit, along the guides on either side. The unit can now be removed from the mounting sleeve. This unit this unit Remove the Detachable Front Panel (refer to page 6). Slide mounting sleeve from main unit (see "Removal" on page 30). Bracket keys (Included) 3. Pull the unit out, keeping it unlocked as you do so. 30-EN