Alpine CDA 9883 Owner Manual - Page 16

Sound Setting Rotary encoder (AUDIO/LOUD) /ESC SOURCE/ BAND A. SEL Adjusting Bass/Treble/Balance (Between Left and Right)/Fader (Between Front and Rear)/Defeat 1 Press Rotary encoder (AUDIO) repeatedly to choose the desired mode. Each press changes the mode as follows: SUBWOOFER*1 BASS TREBLE BALANCE DEFEAT VOLUME SUBWOOFER FADER Subwoofer: 0 ~ +15 Bass level: -7 ~ +7 Treble level: -7 ~ +7 Balance: L15 ~ R15 Fader: R15 ~ F15 Defeat: ON/OFF Volume: 0 ~ 35 • If no operation is performed for 5 seconds after selecting the SUBWOOFER, BASS, TREBLE, BALANCE, FADER or DEFEAT mode, the unit automatically returns to normal mode. *1 When the subwoofer mode is set to OFF, its level cannot be adjusted. 2 Turn the Rotary encoder (AUDIO) until the desired sound is obtained in each mode. By setting Defeat ON, previously adjusted settings of BASS and TREBLE will return to the factory defaults. • Depending on the connected devices, some functions and display indications do not work. Setting the Bass Control You can change the Bass Frequency emphasis to create your own tonal preference. 1 Press A.SEL to select the BASS (Bass Center Frequency) control mode. BASS TREBLE HPF BASS Setting the Bass Center Frequency 2-1 Press BAND to select the desired bass center frequency. 80 Hz 100 Hz 200 Hz 60 Hz 80 Hz Emphasizes the displayed bass frequency ranges. Setting the Bass Bandwidth 2-2 Press SOURCE/ to select the desired bass bandwidth. 1 2 3 4 Changes the boosted bass bandwidth to wide or narrow. A wider setting will boost a wide range of frequencies above and below the center frequency. A narrower setting will boost only frequencies near the center frequency. Setting the Bass Level 2-3*Turn the Rotary encoder to select the desired bass level (-7~+7). You can emphasize or weaken the bass level. 3 Press and hold /ESC for at least 2 seconds to return to normal mode. • If no operation is performed for 15 seconds, the unit will return to normal mode automatically. • The bass level settings will be individually memorized for each source (FM, AM, CD, etc.) until the setting is changed. The bass frequency and bass bandwidth settings adjusted for one source are effective for all other sources (FM, AM, CD, etc.). • Depending on the connected devices, some functions and display indications do not work. However, Bass Level is still adjustable if an audio processor with the Bass function is connected. • The function is inoperable when DEFEAT is set to ON. * The adjustment can also be made by pressing Rotary encoder (AUDIO). Refer to "Adjusting Bass/Treble/Balance (Between Left and Right)/Fader (Between Front and Rear)/Defeat" (page 14). 14-EN