Alpine CDE-163BT Owners Manual - Page 46

iTunes radio tagging With iTunes song tagging, you can tag songs you hear while listening to SiriusXM. The tagging information is saved in your radio until you connect your iPod or iPhone and then the tagging information is transferred to your iPod/iPhone. When your iPod/iPhone is connected to iTunes, you will then be able to preview and purchase the song that you heard while listening to SiriusXM Satellite Radio. For details, refer to the Owner's Manual of the Tagging compatible iPod/iPhone. The m indicator will light when a song playing on a SiriusXM channel has tag information available. Information on using the iTunes song tagging feature is described below: Press and hold k/Tag for at least 2 seconds to save its tag information. During tagging, the m indicator blinks. If no iPod/iPhone is connected, "TAG COUNTX" is displayed (X is the total amount of the tag information stored in this unit). Notes • During tagging, the iPod/iPhone takes priority to save the tag information. • When the memory of iPod/iPhone is full, "iPod FULL" and "TAG COUNTX" are displayed. The tag information will be stored to the unit. • If the operation fails, "CANNOT TAG" is displayed. • This unit can store up to 50 tagged songs. When the memory of the unit is full, "TAGCOUNT50" and "MEMORY FULL" are displayed. • When an iPod that doesn't support the tagging function is connected, "NON-TAGGING IPOD" is displayed. • When the iPod/iPhone is disconnected from the unit during tagging, its tag information will be stored in the unit. • If there is stored tag information on the unit, when an iPod/iPhone supporting the tag function is connected, the stored tag information will be transferred to the iPod/iPhone automatically. When the iPod/iPhone memory becomes full, "iPod FULL" will be displayed, and any remaining tag information on the unit will not be transferred to the iPod/iPhone. • If tag information already exists, "ALREADY TAGGED" will be displayed when you try to tag information again. Changing the Display Text information, such as the channel name, artist name/feature and song/program title, is available with each SiriusXM channel. The unit can display this text information as explained below. In SiriusXM mode, press k. Each time you press this button, the display changes as shown below. Band/Channel Number  Channel Name*  Artist Name*  Song Title*  Content info.*  Category Name*  Clock  Band/Channel Number * If there is no text information, nothing will be displayed. Information In Case of Difficulty If you encounter a problem, please turn the power off, then on again. If the unit is still not functioning normally, please review the items in the following checklist. This guide will help you isolate the problem if the unit is at fault. Otherwise, make sure the rest of your system is properly connected or consult your authorized Alpine dealer. Basic No function or display. • Vehicle's ignition is off. - If connected following instructions, the unit will not operate with the vehicle's ignition off. • Improper power lead (Red) and battery lead (Yellow) connections. - Check power lead and battery lead connections. • Blown fuse. - Check the fuse of the unit; replace with the proper value if necessary. • Internal micro-computer malfunctioned due to interference noise etc. - Press the RESET switch with a ballpoint pen or other pointed article. Radio Unable to receive stations. • No antenna or open connection in cable. - Make sure the antenna is properly connected; replace the antenna or cable if necessary. Unable to tune stations in the seek mode. • You are in a weak signal area. - Make sure the tuner is in the DX mode. • If the area you are in is a primary signal area, the antenna may not be grounded and connected properly. - Check your antenna connections; make sure the antenna is properly grounded at its mounting location. • The antenna may not be the proper length. - Make sure the antenna is fully extended; if broken, replace the antenna with a new one. Broadcast is noisy. • The antenna is not the proper length. - Extend the antenna fully; replace it if it is broken. • The antenna is poorly grounded. - Make sure the antenna is grounded properly at its mounting location. CD (CDE-163BT Only) CD Player not functioning. • Out of operating temperature range +50°C (+120°F) for CD. - Allow the vehicle's interior (or trunk) temperature to cool. CD playback sound is wavering. • Moisture condensation in the CD Module. - Allow enough time for the condensation to evaporate (about 1 hour). CD insertion not possible. • A CD is already in the CD player. - Eject the CD and remove it. 46-EN