Alpine CDE9852 Owners Manual - Page 13

Sound Setting SOURCE/POWER Rotary encoder BAND MENU Setting the Bass Center Frequency 3-1 Press SOURCE/POWER to select the desired bass center frequency. 80Hz 100Hz 120Hz 60Hz 80Hz Emphasize the displayed bass frequency ranges. Setting the Bass Bandwidth 3-2 Press BAND to select the desired bass bandwidth. MODE Adjusting Bass/Treble/Balance (Between Left and Right)/Fader (Between Front and Rear)/Defeat 1 Press MODE repeatedly to choose the desired mode. Each press changes the mode as follows: BASS TREBLE SUBW* BALANCE FADER DEFEAT VOLUME BASS Bass level: -7 ~ +10 Treble level: -7 ~ +7 Subwoofer : 0 ~ +15 Balance : L15 ~ R15 Fader : R15 ~ F15 Defeat : ON/OFF Volume : 0 ~ 35 • If MODE is not pressed within 5 seconds after selecting the BASS, TREBLE, BALANCE, FADER, DEFEAT or SUBW mode, the unit automatically returns to normal mode. * When the subwoofer mode is set to OFF, its level cannot be adjusted. 2 Turn the Rotary encoder until the desired sound is obtained in each mode. By setting Defeat ON, previously adjusted settings of BASS and TREBLE will return to the factory defaults. Change the boosted bass bandwidth to wide or narrow. A wide setting will boost a wide range of frequencies above and below the center frequency. A narrower setting will boost only frequencies near the center frequency. Setting the Bass Level 3-3*1Turn the Rotary encoder to select the desired bass level (-7~+10). You can emphasize or weaken the bass level. 4 Press MENU to select RETURN. After 2 seconds, the unit returns to normal mode. Pressing and holding MENU for at least 2 seconds will return to normal mode. • If no operation is performed within 60 seconds, the bass control setting will be turned off automatically. • The bass level settings will be individually memorized for each source (FM, AM, CD, etc.) until the setting is changed. The bass frequency and bass band width settings adjusted for one source are effective for all other sources (FM, AM, CD etc.). • This function is inoperable when DEFEAT is set to ON. • While in the bass adjusting mode, TREBLE CONTROL adjusting mode can be recalled by pressing or . *1 The adjustment can also be made by pressing MODE. Refer to "Adjusting Bass/Treble/Balance (Between Left and Right)/Fader (Between Font and Rear)/Defeat" (page 12). Bass level indicator's display Bass level is usually displayed Setting the Bass Control You can change the Bass Frequency emphasis to create your own tonal preference. 1 Press MENU to select the BASS ENGINE mode, then press MODE. BASS ENGINE SETUP RETURN (OFF) BASS ENGINE 2 Press or to select the BASS (Bass Center Frequency) control mode. BASS TREBLE 12-EN