Alpine D100 Owners Manual - Page 40

Setting the Picture Output Outputs the picture of the source selected on the IVA-D100 connected to the rear monitor. Setting item: AUX OUT Setting content: OFF / ON ON: The "REAR SELECT" item is displayed on the SETUP select screen. Touch [ ] of REAR SELECT to change to the REAR select screen, then touch [ ] of the desired source. The selected source picture is output on the rear monitor. OFF: The "REAR SELECT" item is not displayed on the SETUP select screen. Setting the VISUAL Button Setting item: VISUAL KEY Setting content: VISUAL / NAV. NAV.: Switches directly to the navigation screen by pressing VISUAL. (Only when an Alpine optional RGB Navigation is connected.) VISUAL: Recalls the VISUAL Select screen by pressing VISUAL. Subwoofer On and Off Setting item: SUBW. OUT Setting contents: ON / OFF ON: Subwoofer output is on. OFF: Subwoofer output is off. Setting the Digital Output To connect an audio processor using the optical digital output, set to "ON" by the following procedure. Setting item: OPTICAL OUT Setting contents: OFF / ON • Afterwards, set ACC to OFF once, then turn it ON again. The setting of Digital Output is decided. DISPLAY Setup Display Setup Operation To display the Display mode screen: To watch a video source, your vehicle must be parked with the ignition key in the ACC or ON position. To do this, follow the procedure below. 1 Bring your vehicle to a complete stop at a safe location. Engage the parking brake. 2 Keep pushing the foot brake and release the parking brake once then engage it again. 3 When the parking brake is engaged for the second time, release the foot brake. • For automatic transmission vehicles, place the transmission lever in the Park position. Now, the locking system for the Display mode operation has been released. Engaging the parking brake can reactivate the Display mode, as long as the car's ignition has not been turned off. It is not necessary to repeat the above procedure (1 through 3), of "To display the Display mode screen." Each time the ignition is turned OFF, perform the procedure of "To display the Display mode screen." The following steps 1 to 5 are common operations to each "Setting item" of DISPLAY Setup. Refer to each section for details. 1 Press SETUP. The SETUP selection screen is displayed. 2 Touch [ ] of OTHER SETUP. The OTHER SETUP screen appears. 3 Touch [ ] of DISPLAY SETUP. The DISPLAY setup screen appears. 4 Touch [ ] or [ ] etc., of the desired item to change its setting. Setting items: DIMMER / DIMMER LOW LEVEL / BACKGROUND / AUTO BACKGROUND / BASE COLOR / PULSETOUCH / SCREEN ALIGNMENT 5 Touch [RTN] to return to the previous screen. • Immediately after changing the settings of Display Mode (While the system is writing data automatically) do not turn the ignition key (engine key) to OFF. Otherwise, the settings may not be changed. 36-EN